Vision VISION-64 Betriebsanweisung PDF herunterladen (Seite 53)

Chapter 4 - The Vision Menus 53

When importing Dahlgren Superpro jobs, you must configure Vision to tell

it which fonts are setup in the Superpro jobs. To do this, you must edit a

file called Dahl2cip.sys in the Viswin folder. You can open this folder

with Windows Notepad. Once it is open, the screen will look like the

following:

If you are importing jobs from Superpro version 3.02, you must edit the

numbers in lines 2 through 9 in the screen above to map out the fonts that

are in your Dahlgren control unit. The first 0 in the file above correlates to

the Dahlgren font 0. Typically, this is the utility font. So, the number that

you would enter for that line would be the Vision font number that

correlates to Utility. Since the default Vision fonts are 1- Gothic, 2 - 3 line

Roman, 3 - 3 line helvetica, 4 - Century & 5 - Utility, you would enter 5 to

match Utility. Typically, the next font in a Dahlgren control unit is Gothic.

So, the number you would enter for the next line is 1, which matches the

Vision Gothic font. You would change the numbers in this file until you

have matched all of the fonts in the Dahlgren control unit.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 186 187

Keine Kommentare

Vision VISION-64 Betriebsanweisung Seite 53