Vision VISION-64 Betriebsanweisung PDF herunterladen (Seite 151)

Chapter 5 - Other Features 151

Re-Engrave

Re-Engrave is a very important feature. There are two types of re-engrave:

plate Re-Engrave and line Re-Engrave.

Plate Re-Engrave is done easily by pressing the F1 button on the Vision

Serial Controller Series I, the B1 button on the Vision Serial Controller

Series II or the Home/Save button on the VE-810 Engraver. When you

press one of those buttons, the start light will turn green. All you need to do

is press the start button and the entire job that was last engraved will

engrave. It does not matter if the job has been closed or not, but Vision

Windows must remain open.

Line Re-Engrave comes in handy especially in multiple jobs in which a

certain line or group of lines did not engrave completely. If you would like

to re-engrave a line, press the F8 or F7 key. This will bring up the display

of the job on the screen. Click on the line that you would like to re-engrave

and press the F9 key. This will bring up the Execute Layout screen.

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 186 187

Keine Kommentare

Vision VISION-64 Betriebsanweisung Seite 151