Vision VISION-64 Betriebsanweisung PDF herunterladen (Seite 156)

156 Vision Software User's Guide

This will show you how far to move your plate for each section that Vision

needed to break the larger job into. Take a pencil and put a mark on your

material that is at the distance listed on your screen from the bottom left

edge of your material. Put as many marks as there are section numbers.

Now click on Okay.

Vision will automatically turn the plate sideways for you. Put your material

on the engraving table sideways with the left edge of the material against the

horizontal edge guide on the table. Press the Start button on the Vision

controller and it will engrave the first section of the sign. When it is done

with the first section, the spindle will move to the home position and wait

for you to move your material.

Move the piece of material so that the first mark that you put on it is where

the back edge guide would normally be. You will need to lower the edge

guide to do this. Press the Start button and the engraver will now engrave

the next section of your plate. Repeat this process for each section that there

is on the plate.

Note: When performing this operation, it is a good idea to use re-usable

double-sided engravers tape to hold your plate down.

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 186 187

Keine Kommentare

Vision VISION-64 Betriebsanweisung Seite 156